Philips REMstar Auto A-Flex - Device Cautions; Contraindications for Therapy; Symbol Key

- 5 -
• Split night start - You can modify the Split night settings on this screen shown here.
Back
CPAP pres (auto min)-(auto max)
Duration 120 180 240
Flex type none C-Flex C-Flex+
Flex 1 2 3
Ramp time 0:00-0:45
Ramp start 4.0-(CPAP pres)
Back
Split night
Split night settings
You can adjust the duration which is the amount of time spent in CPAP therapy before transitioning to Auto-CPAP
therapy. You can set it to 120, 180, or 240 minutes. You can also adjust the CPAP pressure, Flex type, Flex setting, Ramp
time, and Ramp starting pressure from this screen.
Note: This screen only displays if Split night is enabled and Auto-CPAP therapy is enabled.
Note: If Split night is enabled, Ramp start will be disabled.
• Silent mode - You can disable this feature if you want the device to emit an audible indicator (beep) during the following
device operations: power on, therapy start, therapy stop, mask t check, and humidier preheat mode. The device defaults
to the Silent mode being enabled, meaning the device does not emit a beep during these operations. The patient also has
access to this feature.
• Language - This feature allows you to choose which language to display on the interface. You can choose English (EN), or
Spanish (ES).
Info Screen
From the Provider screen, highlight “Info” and press the control wheel. The following Info screen will appear.
Info
Back
Phone-in
Compliance VIC
Therapy hours
Blower hours
Days > 4
Large leak
AHI
Periodic breathing
90% pressure
Reset data
Machine hours
Humidier
Back
Info Screen
Note: The screen will only show a few lines at a time. As you rotate the control wheel to toggle over different options
the screen will slide up and down accordingly.
• Phone-in - This screen displays the total therapy hours for the device, the total blower hours, and the total number
of days used when the sessions were greater than 4 hours since the device was last reset. This screen also displays a
compliance check number you can use to validate that the data provided to you is the data taken from this screen.
• Compliance VIC (Visual Inspection Check) - This screen displays the start day and the total number of days used
when the sessions were greater than 4 hours. This screen also displays a check code number you can use to validate that
the data provided to you is the data taken from this screen.