Philips REMstar Pro C-Flex+ - System Components and Overview; System Contents List; System Overview and Capabilities

5User Manual
System Contents
Your REMstar Pro C-Flex+ system may include the following items:
• Device • SD card
• User manual • Side cover panel
• Carrying case • Reusable gray foam lter
• Flexible tubing • Disposable ultra-ne lter (optional)
• Power cord • Humidier (optional)
• Power supply (60W 1091398, or 80W 1091399)
Note: If any of these items are missing, contact your home care provider.
System Overview
The REMstar Pro C-Flex+ is a CPAP (Continuous Positive Airway Pressure) device designed for the treatment of
Obstructive Sleep Apnea (OSA). CPAP maintains a constant level of pressure throughout the breathing cycle. If
your provider uses either the CPAP-Check or Auto-Trial modes, the device can also deliver CPAP therapy while
automatically adjusting the pressure level to meet the patient’s needs.
When prescribed for you, the device provides several special features to help make your therapy more comfortable.
The ramp function allows you to lower the pressure when you are trying to fall asleep. The air pressure will gradually
increase until your prescription pressure is reached. You also have the option of not using the ramp feature at all.
Additionally, the A-Flex (if using the Auto-Trial mode), C-Flex, and C-Flex+ comfort features provide you with
pressure relief when you exhale during therapy.
Several accessories are also available for use with your REMstar Pro C-Flex+ device. Contact your home care
provider to purchase any accessories not included with your system.
Air Outlet Port
Power Inlet
Filter Area
SD Card (Accessory) Slot
Side Cover
Ta b
SD Card Cover
This gure illustrates some of the device features, described in the following table.
De v i c e fe a t u r e De S c r i p t i o n
Air Outlet Port
(conical, 22 mm)
Connect the 15 or 22 mm Philips Respironics exible tubing here.
Note: Heated Tubing should only be connected to the Air Outlet Port of the compatible
System One Heated Humidier and not to the Air Outlet Port of the therapy device.
SD Card (Accessory) Slot If applicable, insert the optional accessory SD card here.
SD Card Cover If applicable, the optional accessories such as a Link Module or Modem can be installed here.
Refer to the instructions supplied with the accessory. When not using an accessory, this
cover must be in place on the device.
Power Inlet Connect the power cord here.
Filter Area A reusable, gray foam lter must be placed in the lter area to screen out normal household dust and
pollens. A white ultra-ne lter can also be used for more complete ltration of very ne particles.
Side Cover If using a humidier with the device, this side cover can be easily removed with the release
tab before attaching the humidier. Refer to the humidier manual. When not using a
humidier, this cover must be in place on the device.