EasyManua.ls Logo

Philips Respironics EasyLife User Manual

Philips Respironics EasyLife
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
1
EasyLife
Instructions for Use
Intended Use
The EasyLife Nasal Mask is an accessory to a non-continuous ventilator (respirator). The
mask is for single patient use in the home or multi-patient use in the hospital/institutional
environment. The mask is to be used on patients (>66lbs/30kg) for whom CPAP or bi-level
therapy has been prescribed.
Notes:
An exhalation port is built into this mask so a separate exhalation port is not required.
This mask does not contain natural rubber latex or DEHP.
Caution: U.S. Federal law restricts this device to sale by or on the order of a physician.
Symbols
Warning or Caution
Note Tip
Consult Instructions for
Use
Does Not Contain
Natural Rubber Latex
System One Resistance
Control
Warnings
• This mask is not suitable for providing life support ventilation.
• This mask is designed for use with CPAP or bi-level systems recommended by your health care
professional or respiratory therapist. Do not wear this mask unless the CPAP or bi-level system is
turned on and operating properly. Do not block or try to seal the exhalation port. Explanation of
the Warning: CPAP systems are intended to be used with special masks with connectors which have
vent holes to allow continuous flow of air out of the mask. When the CPAP machine is turned on and
functioning properly, new air from the CPAP machine flushes the exhaled air out through the attached
mask exhalation port. However, when the CPAP machine is not operating, enough fresh air will not be
provided through the mask, and exhaled air may be rebreathed. This warning applies to most models of
CPAP systems. Rebreathing of exhaled air for longer than several minutes can, in some circumstances,
lead to suffocation.
• If oxygen is used with the device, the oxygen flow must be turned off when the device is not operating.
Explanation of the Warning: When the device is not in operation, and the oxygen flow is left on,
oxygen delivered into the ventilator tubing may accumulate within the device enclosure. Oxygen
accumulated in the device enclosure will create a risk of fire.
• Oxygen supports combustion. Oxygen should not be used while smoking or in the presence of an
open flame.
• At a fixed flow rate of supplemental oxygen flow, the inhaled oxygen concentration will vary, depending
on the pressure settings, patient breathing pattern, mask selection, and the leak rate. This warning
applies to most types of CPAP and bi-level machines.
• Some users may experience skin redness, irritation, or discomfort. If this happens, discontinue use and
contact your healthcare professional.
• At low CPAP or EPAP pressures, the flow through the exhalation port may be inadequate to clear all
exhaled gas from the tubing. Some rebreathing may occur.
• Hand wash prior to first use. Inspect the mask for damage or wear (cracking, crazing, tears, etc). Discard
ENGLISH
Question and Answer IconNeed help?

Do you have a question about the Philips Respironics EasyLife and is the answer not in the manual?

Philips Respironics EasyLife Specifications

General IconGeneral
BrandPhilips
ModelRespironics EasyLife
CategoryRespiratory Product
LanguageEnglish

Summary

Mask Overview and Safety

Intended Use

Specifies the mask's purpose and patient suitability for CPAP or bi-level therapy.

Warnings and Precautions

Details critical safety advice, including life support limitations and oxygen use hazards.

Preparation and Maintenance

Before Use

Advises on essential pre-use steps like washing the mask and face.

Cleaning Instructions

Provides detailed steps for hand washing the mask and headgear.

Institutional Disinfection

Outlines procedures for multi-patient reprocessing of the mask.

System One Compatibility

Explains how the mask interacts with System One devices for resistance compensation.

Using the Mask

Headgear Adjustment

Guides on connecting, adjusting, and using headgear and optional clips for fit.

Comfort and Fit Tips

Offers advice on achieving a comfortable fit and reseating the mask.

Mask Removal

Explains the process of disconnecting straps and sliding the headgear off.

Cushion Management

Details steps for detaching and reattaching the inner and outer mask cushions.

Technical Specifications and Support

Technical Specifications

Lists technical details for healthcare professional compatibility assessment.

Disposal and Storage

Advises on proper mask disposal and specifies storage conditions.

Limited Warranty

Details the warranty period, coverage, and disclaimers for the mask system.

Related product manuals