39
2 Move the shaving heads over your skin in
circular movements.
Do not make straight movements.
3 Press the on/off button once to switch off the
shaver.
RQ1195/RQ1180/RQ1175: The display lights up
for a few seconds and then shows the remaining
battery capacity.
Wet shaving
You can also use this shaver on a wet face with
shaving foam or shaving gel.
To shave with shaving foam or shaving gel, follow the
steps below:
1 Apply some water to your skin.
2 Apply shaving foam or shaving gel to your skin.
3 Rinse the shaving unit under the tap to ensure
that the shaving unit glides smoothly over your
skin.
4 Press the on/off button once to switch on the
shaver.
5 Move the shaving heads over your skin in
circular movements.
Note: Rinse the shaver under the tap regularly to
ensure that it continues to glide smoothly over your
skin.
6 Dry your face and thoroughly clean the
shaver after use (see chapter ‘Cleaning and
maintenance’).
Note: Make sure you rinse all foam or shaving gel off
the shaver.
-
,
ENGLISH
DFU_RQ1185CC_1155_EN_CS2_A6.indd39 39 12.4.13 10:02:17 PM
To Next Page
Loading...
