48
5 Place the Jet Clean System back onto the
cleaning chamber.
Make sure the release buttons click back into place.
Extra-thorough cleaning method
Make sure the appliance is switched off.
1 Pull the shaving head holder off the bottom
part of the shaving unit.
2 Slide the green retaining frame in the direction
of the arrows indicated on the retaining frame.
3 Lift the retaining frame out of the shaving head
holder.
4 Remove the cutter from the shaving guard.
Note: Do not clean more than one cutter and shaving
guard at a time, since they are all matching sets. If you
accidentally put a cutter in the wrong shaving guard,
it may take several weeks before optimal shaving
performance is restored.
ENGLISH
DFU_RQ1185CC_1155_EN_CS2_A6.indd48 48 12.4.13 10:02:36 PM
To Next Page
Loading...
