56
Problem Possible cause Solution
Specic types
only: The shaver
is not entirely
clean after I clean
it in the Jet Clean
System.
The cleaning uid in
the cleaning chamber is
soiled.
Empty and rinse the
cleaning chamber and
rell it with new cleaning
uid.
The cleaning uid level
is too low. If the uid
volume in the cleaning
chamber drops below
the minimum level
during the cleaning
program, the program
aborts.The cleaning
light and the ‘cleaning
chamber empty’ symbol
ash at intervals and
the holder returns to its
starting position.
Rell the cleaning
chamber with cleaning
uid to a level between
the two lines (see
chapter ‘Cleaning and
maintenance’).
You have used another
cleaning uid than the
original Philips cleaning
uid.
Only use HQ200
Philips Cleaning Fluid.
Specic types
only: The Jet
Clean System
does not work
when I press the
on/off button.
The Jet Clean System
is not connected to the
mains.
Put the small plug in the
Jet Clean System and
put the adapter in the
wall socket.
ENGLISH
DFU_RQ1185CC_1155_EN_CS2_A6.indd56 56 12.4.13 10:02:44 PM
To Next Page
Loading...
