Philips RQ1250 - Addressing Shaving Performance Problems

Problem Possible cause Solution
Long hairs obstruct the
shaving heads.
Clean the shaving
heads by following
the steps of the
extra-thorough
cleaning method (see
chapter ‘Cleaning and
maintenance’).
The Jet Clean System
has not cleaned the
shaver properly, because
the cleaning uid in the
cleaning chamber is soiled
or the cleaning uid level is
too low.
Clean the shaver
thoroughly before
you continue shaving.
If necessary, clean
and rell the cleaning
chamber (see
chapter ‘Cleaning and
maintenance’).
The shaver does
not work when I
press the on/off
button.
The rechargeable battery
is empty.
Recharge the
battery (see chapter
‘Charging’).
The travel lock is activated.
Press the on/off
button for 3 seconds
to deactivate the
travel lock.
The shaving unit is soiled or
damaged to such an extent
that the motor cannot run.
In this case, the shaving unit
symbol, the tap symbol and
the exclamation mark ash.
Clean the shaving
unit or replace it (see
chapters ‘Cleaning
and maintenance’ and
‘Replacement’).
ENGLISH
49