Problem Possible cause Solution
The Jet Clean
System does not
work when I
press the on/off
button.
The Jet Clean System is not
connected to the mains.
Put the small plug in
the Jet Clean System
and put the adapter in
the wall socket.
You have not placed the
shaver in the Jet Clean
System properly, so there
is no electrical connection
between the Jet Clean
System and the shaver.
Press the shaver
tightly into the holder
to lock it into place.
The shaver is
not fully charged
after I charge it
in the charger/
Jet Clean
System.
You have not placed the
shaver in the charger/Jet
Clean System properly.
Make sure you press
the shaver until it
locks into place.
RQ1008: The
operating
time of the Jet
Clean System is
suddenly shorter
or longer than it
was earlier.
You have selected another
cleaning program. The Jet
Clean System has three
cleaning programs: the
eco program, the normal
program and the intensive
program. Each of these
programs has a different
operating time.
Press the up/down
button on the Jet
Clean System to
select the cleaning
program of your
preference (see
chapter ‘Cleaning and
maintenance’).
ENGLISH
51
To Next Page
Loading...
