Philips S93 Series - Cleaning the shaver in the SmartClean system; Preparing the SmartClean system for use

Cleaning the shaver in the SmartClean system
SmartClean system Plus has two phases: the
rinsing phase and the drying phase.
Preparing the SmartClean system for use
Caution: Do not tilt the SmartClean system to
prevent leakage.
Note: Hold the SmartClean system while you
prepare it for use.
Note: If you clean the shaver in the SmartClean
system once a week, the SmartClean cartridge
lasts approximately three months.
1 Put the small plug in the back of the
SmartClean system.
2 Put the supply unit in the wall socket.
2
1
3 Press the button on the side of the SmartClean
system (1) and lift the top part of the
SmartClean system (2).
4 Pull the seal off the cleaning cartridge.
22
English