Philips S9711/31 - Page 29

4 Remove the shaving heads from the shaving
head holder.
Throw away the used shaving heads
immediately to avoid mixing them with the new
shaving heads.
5 Place the shaving heads in the shaving head
holder.
Note: Make sure the notches on both sides of
the shaving heads fit exactly onto the
projections in the shaving head holder.
3
1
2
6 Place the retaining ring holder on the retaining
ring (1), place it on the shaving head (2) and turn
it clockwise (3) to reattach the retaining ring.
Repeat this process for the other retaining rings.
-
Each retaining ring has two recesses that fit
exactly into the projections of the shaving
head holder. Turn the ring clockwise until
your hear a click to indicate that the ring is
fixed.
2
1
Note: Hold the shaving head holder in your
hand when you reinsert the shaving heads and
reattach the retaining rings. Do not place the
shaving head holder on a surface when you do
this, as this may cause damage.
7 Attach the shaving head holder to the bottom
part of the shaving unit (‘click’).
29
English