Problem Possible cause Solution
Clean the shaver thoroughly
before you continue shaving
(see chapter ‘Cleaning and
maintenance’).
I replaced the
shaving heads, but
the replacement
reminder is still
showing.
You have not reset the
shaver.
Reset the shaver by pressing
the on/off button for approx.
7 seconds (see chapter
‘Replacement’).
A shaving head
symbol has
suddenly appeared
on the display.
This symbol is a
replacement reminder.
Replace the shaving heads
(see chapter ‘Replacement’).
An exclamation
mark has suddenly
appeared on
the display while
charging.
The shaver is
overheated.
Disconnect the shaver from the
mains for approx. 10 minutes.
An exclamation
mark, replacement
reminder and the
cleaning reminder
have suddenly
appeared on the
display.
The shaving heads are
soiled or damaged.
Replace (see chapter
‘Replacement’) or clean the
shaving heads (see chapter
‘Cleaning and maintenance’).
Water is leaking
from the bottom
of the shaver.
During cleaning, water
may collect between
the inner body and the
outer shell of the shaver.
This is normal and not
dangerous because all
electronics are enclosed in a
sealed power unit inside the
shaver.
The SmartClean
system does not
work when I press
the on/off button.
The SmartClean system
is not connected to the
mains.
Put the small plug in SmartClean
system and put the adapter in
the wall socket.
ENGLISH 33
To Next Page
Loading...
