Philips SA4100 - 7 Technical Data

9Technical data
ENGLISH
7 Technical data
Power
• Power supply: AAA alkaline battery*
Display
• Picture / Display: Mono display, 32 x 128 pixels, 7 colour LCD
backlight
Sound
• Channel separation: 45dB
• Equalizer settings: Rock / Jazz / Pop / Classical / Off
• Frequency response: 30-18000Hz
• Signal to noise ratio: > 85dB
• Output Power (RMS): 2x3mW
Audio Playback
• Compression format: MP3 (8-320 kbps and VBR; Sample rate: 8,
11.025, 16, 22.050, 24, 32, 44.1, 48kHz), WAV, WMA (5-192kbps)
• ID3-tag support: Song title and artist name
Recording
• Audio Capturing: Built-in microphone (Mono)
Storage Media
• Built-in memory capacity:
SA410X 512MB NAND Flash
+
SA411X 1GB NAND Flash
+
SA412X 2GB NAND Flash
+
Connectivity
• Headphone 3.5mm, USB 2.0
++
Music transfer
• Windows Media Player 10
System Requirements
• Windows® XP (SP2 or above)
• Pentium Class 300MHz processor or higher
• 128MB RAM
• 500MB hard disk space
• Internet connection
• Microsoft Internet Explorer 6.0 or later
• Video display card
• Sound card
• USB port
* Battery life vary by use and settings.
+ 1MB = 1 million bytes; available storage capacity will be less.
1GB = 1 billion bytes; available storage capacity will be less.
Full memory capacity may not be available as some memory will be
reserved for the player.
Storage capacity based on 4 minutes per song and 64kbps WMA
encoding.
++ Actual transfer speed may vary based on your operating system and
software configuration.