Philips Savvy - Page 28

3.5
confirm the receipt of a sent text message
When sending an important text message to another
mobile phone, add ‘RCT’ to the beginning of the
message. This requests a confirmation text message
to be sent back to your phone to confirm that the text
message has been delivered.
send, delete or edit a saved message
1 Press ‘MENU’, then ‘<’ to move to <Messages>.
2 Press ‘OK’ to move to <Send>, then ‘<’ to move to
<Archive>.
3 Press ‘OK’ to go to your saved messages, then ‘<’
or ‘>’ to move to the message you wish to select.
4 Press ‘OK’ to check the contents of the message.
You may have to press ‘OK’ again to view the end of
the message.
5 Press ‘OK’ again to go to the message options.
Delete> to delete the message, <Reply>
to reply to the message, <Forward> to forward the
message to another number, <Usual msg.> to add a
pre-programmed message or <Store no , to
store the number of the message.
6 If you have selected <Forward> press ‘OK’to enter
the number, or alternatively press ‘OK’ again to select
a number from your Phonebook. Press ‘OK’ to check
the number and edit it if necessary. Press ‘OK’.
At this stage you can edit the message if you wish, add a
p i c t u r e message and send.
send a pre-programmed message
There are 13 pre-programmed messages available,
to save you time when sending text messages.
Some have icons included.
1 Press ‘MENU’.
2 Press‘<’ to move to <Messages>.
3 Press ‘OK’ to move to <Send>.
4 Press ‘>’ to move to <Usual msg. .
5 Press ‘OK’ to go to the pre-programmed messages,
listed on the right of this page.
6 P re s s ‘OK’ to enter the number, or alternatively press
‘OK’ again to select a number from your Phonebook.
Press ‘OK’ to check the number and edit it if necessary.
Press ‘OK’. At this stage you can edit the message if
you wish, add a picture message and send.
key
1
2
3
4
5
6
7
8
9
0
*
#
Characters
sp a c e 1 @ # = < > ( ) & £ $ ¥
a b c 2 à ä å æ ç
d e f 3 é è ∆ Φ
g h i 4 Γ ì
j k l 5 Λ
m n o 6 ñ ò ö ø
p q r s 7 β Π Θ Σ
t u v 8 ü ù
w x y z 9 Ω Ξ ψ
. 0 ” ’ ? ! , : ¡ ¿
* + - / %
Switches upper-case/lower-case mode
Each key allows you
to obtain several
characters.You have
to quickly press the
same key several
times to reach the
desired character.
‘AB’
shows that you are in
upper-case mode.
‘ab’
shows you are in the
lower-case mode.