Safety Warnings ...................................................................................................................................................... 1
Important! ................................................................................................................................................................ 1
Electrical Installation................................................................................................................................................ 2
Lamping up .............................................................................................................................................................. 3
Adjusting the tilt angle ............................................................................................................................................. 4
Adjusting the pan angle ........................................................................................................................................... 4
Inserting colour filters or other accessories ............................................................................................................ 4
Accessories include:................................................................................................................................................ 4
Safety and maintenance ......................................................................................................................................... 4
Safety Warnings
CAUTION: Hot Surfaces: avoid contact by persons or materials. The BeamSpot has some hot surfaces. Be
careful to avoid burns.
DANGER: Chaleur Intense. Eviter tout contact et tenir toute matiere a l‟ecart.
SAFETY - The BeamSpot has a built in transformer which converts the local voltage into the 12V required
by the lamp. Always isolate the luminaire electrically from mains power before re-lamping.
SÛRETÉ - Le BeamSpot a un transformateur qui convertit la tension locale au 12V exigé par la lampe.
Coupez toujours la tension electrique avant de changer la lampe.
CAUTION: Risk of fire.
220-240V: maximum 50W lamp for copper wound transformer model and maximum 75W lamp for
electronic transformer models.
120V: maximum 50W lamp for all transformer models – copper wound and electronic.
Suitable for dry locations only. These luminaires are not suitable for outdoor use.
Approprié aux emplacements secs seulement. Impropre a l‟usage exterieur.
Important!
Read this manual carefully before attempting to install, operate or maintain the Aureol BeamSpot. It contains important
installation, operating, maintenance and safety procedures. The customer must strictly comply with them.
Along with such procedures mentioned in this document, the customer should also observe such other procedures generally
applicable to lighting equipment.
Follow the instructions in this manual. Philips Selecon accepts no responsibility if the customer fails to do so.
For each customer, operating conditions will vary, sometimes greatly. Such variations may affect the luminaires‟
performance. Philips Selecon has no control over the customer‟s unique operating environment. Hence, Philips Selecon
makes no representations or warranties concerning the luminaires‟ performance under the customer‟s actual operating
conditions. All operating parameters must be validated for each customer application by the customer‟s technical experts.
AUREOL BEAMSPOT
OPERATION MANUAL
Thank you for purchasing a Philips Selecon Aureol BeamSpot. We have designed this luminaire to provide
superior performance in design and engineering and we are confident that it will perform to your expectations
for many years.
This manual will provide you with information to assist you in making maximum use of your luminaire, its
maintenance, and care. If you require further assistance please contact your Philips Selecon distributor:
www.seleconlight.com/distributors
Caution!
Installation is entirely at your risk. Read this manual from cover to cover before attempting installation. Do not
attempt installation unless you are suitably qualified. If you do not understand a point in this manual, please
contact your Philips Selecon distributor for advice. Don’t be afraid to ask for help.
To Next Page
Need help?
General
