Philips Sonicare 2 Series - Preparing for use; Using the appliance; Brushing instructions

, To activate Easy-start: Press and hold the power
on/off button for 2 seconds. You hear 2 beeps
andthebatterylevelindicatorashesgreento
indicate that the Easy-start feature has been
activated.
, To deactivate Easy-start: Press and hold the
power on/off button for 2 seconds. You hear
1beepandthebatterylevelindicatorashes
yellow to indicate that the Easy-start feature has
been deactivated.
Note: Each of the rst 14 brushings must be at least
1 minute in length to properly move through the Easy-
start ramp-up cycle.
Note: Using the Easy-start feature beyond the initial
ramp-up period is not recommended and reduces
Sonicare’s effectiveness in removing plaque.
Cleaning
Do not clean the brush head, handle or charger in
dishwasher.
Toothbrush handle
1 Remove the brush head and rinse the metal
shaft area with warm water.
Do not push on the rubber seal on the metal shaft
with sharp objects, as this may cause damage.
2 Use a damp cloth to wipe the entire surface of
the handle.
ENGLISH10