Philips Sonicare HX6220 - Preparing for Use; Attaching the Brush Head; Charging the Appliance; Using the Appliance

Preparing for use
Attaching the brush head
1 Align the brush head so the bristles face the front of the handle
(Fig. 2).
2 Firmly press the brush head down on the metal shaft until it stops.
Note: Sonicare brush heads come with easily identiable icons to identify your
brush head.
Charging the appliance
1 Put the plug of the charger in a wall socket.
2 Place the handle on the charger (Fig. 3).
, Thebatterylevelindicatorashestoindicatethatthetoothbrush
ischarging.Whenthelightstopsashingandturnssolidgreenthe
toothbrush is fully charged (Fig. 4).
Note: It can take up to 48 hours to fully charge the battery, but the Sonicare
may be used before it is fully charged.
Using the appliance
Brushing instructions
1 Wet the bristles and apply a small amount of toothpaste.
2 Place the toothbrush bristles against the teeth at a slight angle
towards the gumline (Fig. 5).
3 Press the power on/off button to switch on the Sonicare.
4 Apply light pressure to maximise Sonicare’s effectiveness and let
the Sonicare toothbrush do the brushing for you. Do not scrub.
5 Gently move the brush head slowly across the teeth in a small back
and forth motion so the longer bristles reach between the teeth.
Continue this motion throughout the brushing cycle.
Note: To make sure you brush evenly throughout the mouth, divide the mouth
into 4 sections using the Quadpacer feature (see chapter ‘Features’), (specic
types only).
ENGLISH 9