EasyManua.ls Logo

Philips Sonicare - Brushing Instructions

Philips Sonicare
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
, To deactivate Easy-start: Press and hold the
power on/off button for 2 seconds. You hear
1 beep to indicate that the Easy-start feature
has been deactivated.
Note: Each of the rst 14 brushings must be at least
1 minute in length to properly move through the Easy-
start ramp-up cycle.
Note: Using the Easy-start feature beyond the initial
ramp-up period is not recommended and reduces
Sonicare’s effectiveness in removing plaque.
Cord wrap on charger (select models)
If your model includes the charger cover and base,
the travel charger is pre-installed inside the cover.
1 To separate the charger cover from the
charger base, press the two gray snap bars on
the charger base and pull the white charger
cover upwards.
2 Wrap excess power cord around the gray
charger base as shown in the picture. Be sure
to wrap the cord on the inside of the two snap
levers. Guide the power cord through the small
groove in the rear of the charger base.
3 To reattach the charger cover, press it down
over the charger base until it snaps into place.
Tip: For extra convenience during travel, you can
remove the travel charger and use it without the
charger cover and charger base.
ENGLISH 13

Other manuals for Philips Sonicare

Related product manuals