9User manual
4 Use your SpeechMike
This chapter describes how to use the
SpeechMike with Philips SpeechExec dictation
software. If the SpeechMike is used with third-
party software other than Philips SpeechExec,
some features may not be present or function
dierently. For detailed information, refer to the
documentation delivered with the software.
4.1 Create a recording
1 The dictation microphone must be
connected to the computer with the USB
cable.
2 Start SpeechExec dictation software.
3 Press the d
RECORD key to create a new
recording and enter Record standby mode.
• The recorder window is displayed.
• The record indicator light flashes red (in
overwrite mode) or green (in insert mode).
4 Press the e key and start speaking.
The record indicator light glows in red (in
overwrite mode) or green (in insert mode) while
recording.
5 For short pauses, press the e key. To
continue recording, press the e key again.
6 To stop recording, press the d
RECORD key.
7 Press the
•EOL/••PRIO key to mark the
recording as finished.
• The dictation file is moved to the Finished
dictations folder.
• The recorder window closes and the work list
window is displayed.
8 To assign priority status to the recording,
press the
•EOL/••PRIO key again within half
a second.
D Note
For best results, speak clearly and keep the
microphone about 10 to 15 centimeters (4 to 6
inches) away from your mouth.
4.2 Use the bar-code scanner (LFH3600
only)
1 Press the scan button and scan the
barcode. When a barcode is recognized,
the SpeechMike will beep and the barcode
information is inserted into the currently
active application as if the barcode number
is typed in digit by digit.
D Note
The barcode scanner allows barcode scanning
from a distance of up to 60 cm / 23 inches.
ENGLISH
To Next Page
Loading...
