13EN
English
How do I set the remote control for combo devices (TV /
VCR, TV / DVD, DVD / VCR, etc)?
Some combo devices require you to set up two different
source selection keys to control both parts of the combo
device. For example, if you have a TV / DVD combo, you
might need to set up the remote control for both TV and
DVD to operate your TV / DVD combo.
Operation
The remote control does not wake up anymore.
Battery level too low or battery lifetime came to an end.
• Replace the batteries. See chapter 2.1.
The device I want to operate does not respond at all /
does not respond to all of the key commands.
• Check if the keys you press are available on the original
remote control of the device.
• Try improving
keys
. See chapter 2.3.2.
Not all key functions are available in the database of the
remote control.
• Try learning key functions from the original remote
control. See chapter
3.2.
Wrong code selected during setup.
• Set up the remote control again for the device. Always
test if the device responds, before leaving setup mode.
See chapter 2.2.
It may be that the keys that you are trying to use have a
different naming on the original remote control.
• Try out all keys to find the one(s) you need.
The Teletext keys do not work.
• Find out whether your TV is equipped with Teletext.
• Try improving the Teletext
keys
. See chapter 2.3.2.
• Check whether you are using the correct keys to switch
on Teletext. For TV this is the
key; for STB this is the
k
ey.
Batteries
Will my settings be deleted when I replace the batteries?
No.
All user settings will be retained in the remote control
memory during battery replacement.
Service and support
SRP5004_53_Manual_DEF.indd 13 01-06-09 12:49
To Next Page
Loading...
