Philips SRP5004/53 - Getting Started - Remote Setup Procedure; Setting Up Universal Remote Control

5EN
2.3 Setting up the universal remote control
This is only necessary if your device does not respond to the
SRP5004. If that is the case, the SRP5004 does not recognize
the brand and / or model of your device and you need to set
up the remote control to do so.
The example below instructs you how to do this for your TV.
You can repeat the same steps for other devices (
STB, DVD
player/recorder and VCR
) which you want to operate, using
the SRP5004.
The remote control can be set up to operate any 4 of the
following devices:
Device name Description
TV Traditional TV, at screen TV and
projection TV, TV part of TV / VCR, TV /
VCR / DVD and TV / DVD combos
STB Cable box, satellite receiver, Digital
Video Broadcasting Terrestrial device
(DVB-T), Internet Protocol TV
(IPTV), Free To Air TV, High Denition
Television decoder (HDTV)
DVD DVD player / recorder (DVDR), DVD /
Hard Disk Drive combination (DVDR-
HDD), Blu-Ray player, High Denition
DVD player (HD-DVD), DVD part of
TV / DVD, TV / VCR / DVD and VCR /
DVD combos
VCR Video cassette player / recorder, VCR
part of TV / VCR, TV / VCR / DVD and
VCR / DVD combos
Example: setting up the universal remote control to
operate your TV:
1 Turn ON the TV manually or use the original remote
control for this. Tune to channel 1.
2 Press and holdthe
device selection key
for 5 seconds until the red
Setup LED
lights up.
• The remote control is
now in setup mode.
Getting started English
5 sec.
SRP5004_53_Manual_DEF.indd 5 01-06-09 12:49