Philips SRP5004/53 - Using the Universal Remote Control - Key Overview; Keys and Functions Overview

6 EN
3 Look up the brand of your
TV in the Code list for TV
brands
at the back of this
user manual.
A four-digit code is shown
for each brand.
Use the digit keys to enter
the code for your brand
(e.g. Philips TV,
).
• If the red Setup LED
turns off, an invalid code
was entered. In this case,
try again.
4 Aim the remote control at
the TV. Press and hold the
key and immediately
release it when the TV turns
off (standby).
•
This step normally
takes between 5 and 60 seconds. In extreme
circumstances this step can take up to 15 minutes.
5 Turn on the TV and check
if all keys that you need for
operating your TV are
working. Try, for example, if
the - CH + and digit keys
function properly.
• If a key does not function as expected, press and hold it
and immediatley release it as soon as it works. For more
information, see chapter 2.3.2.
6 Press the device
selection key twice to save
your settings and exit setup
mode.
•
When no key is
pressed for 5 minutes
or more, the remote control will exit setup mode,
automatically saving all your settings.
Note
• If you wish to restart setup, you can start again from
the beginning at any time.
5 - 60 sec.
5-60 SEC
.
2 x
SRP5004_53_Manual_DEF.indd 6 01-06-09 12:49