12 EN
3.3 Resetting a key to its original function
When resetting a key to its original function, any learned
function stored under the key will be deleted.
1
In the current device
mode, keep digit keys
and
pressed
simultaneously for 5 seconds,
until the red Setup LED
lights up.
• The remote control is now in setup mode.
2
Press digit keys , ,
and ,
in that order.
• After each key press
the device selection key
blinks once.
3
Press the key you wish to
reset twice. E.g. the 22 key.
• After each key press
the device selection key
blinks once.
• The device selection key
will blink one more time to confirm that the key was
succesfully reset to its original function.
• The key can now also learn a new function, if desired.
4 Service and support
4.1 Frequently asked questions
In this chapter you will find answers to the most frequently
asked questions about your universal remote control.
Setup
I cannot enter setup mode.
Battery level too low or battery lifetime came to an end.
• Replace the batteries. For this see chapter 2.1.
5 sec.
2 x
SRP5004_53_Manual_DEF.indd 12 01-06-09 12:49
To Next Page
Loading...
