English
EN 9
4
When the device is off, immediately press and release OK to save
the code. The red LED indicator will turn off.
5
Operate the device with the universal remote. If your device
responds correctly, it means you have saved the right code.
Note
•
Auto registration can be reversed, by pressing and releasing once more during
the auto registration process. This is helpful if you missed out the chance to press OK
within 2 seconds. Make sure that the device is rst powered on again.
• Repeat the same procedures to set up other devices.
• It is possible sometimes that your device only responds to some of the buttons. In such
case, set up with the next code in the code list, and try operating your device again.
• You may also x the buttons which are not functioning properly by using the learning
feature (see 'Use your universal remote control' on page 10).
max. 20
minutes
To Next Page
Loading...
