English
EN 7
4
Enter the rst 5-digit code using the digit buttons.
5
If the light is off, a valid code is saved. Otherwise, the light will ash
once, and then remains on for code re-entry.
6
Operate the device with the universal remote. If your device
responds correctly, it means you have entered the right code.
Otherwise, repeat from step 2, and enter the second code on the
list.
Note
•
It is possible sometimes that your device only responds to some of the buttons. In
such case, set up with the next code in the code list, and try operating your device
again.
• You may also x the buttons which are not functioning properly by using the learning
feature (see 'Use your universal remote control' on page 10).
To Next Page
Loading...
