Cleaning the shaving unit
3 Pull the shaving unit off the appliance. (Fig. 16)
Note: The shaving unit is very delicate. Handle it carefully. Replace the
shaving unit if it is damaged.
4 Rinse the shaving unit with lukewarm water. (Fig. 17)
Do not clean the shaving unit with the brush, as this may cause damage.
5 Remove hairs from the hair chamber with the cleaning brush and/
or with lukewarm water (Fig. 18).
6 After cleaning, snap the shaving unit back onto the appliance
(‘click’) (Fig. 19).
Cleaning the trimming unit
7 Remove the trimming comb by sliding it off the appliance.
8 Push the middle part of the trimming unit upwards with your
thumb until it opens (Fig. 20).
9 Remove hairs from the hair chamber with the cleaning brush and/
or with lukewarm water. (Fig. 21)
10 Rinse the trimming unit with lukewarm water (Fig. 22).
11 After cleaning, close the trimming unit and reattach the trimming
comb. (Fig. 23)
Replacement
In case of frequent use, replace the shaving unit (type number TT2000)
every year. Replace a damaged shaving unit immediately. To replace the
shaving unit:
1 Pull the shaving unit off the appliance. (Fig. 16)
2 Snap the new shaving unit onto the appliance (‘click’) (Fig. 19).
ENGLISH
22
To Next Page
Loading...
