4.
4.
Press . The program number
you have just set will be displayed.
5.
5.Insert a cassette with an intact security tab
(unprotected).
6.
6.Switch off with .
The programmed record-
ing will only function
when the video recorder
is switched off with .
How to check, or delete a pro-
grammed recording (TIMER)
1.
1.Switch on the TV. If required, select the pro-
gramme number for the video recorder.
2.
2.Press . The main menu will appear.
3.
3.Select 'TIMER' with or .
Then press .
4.
4.Select 'TIMER LIST' with or ,
and confirm with
.
5.
5.Select timer block with .
6.
6.To cancel the recording, press .
7.
7.To end, press
.
8.
8.Switch off with
.
How to change a programmed
recording (TIMER)
1.
1.Switch on the TV. If required, select the pro-
gramme number for the video recorder.
2.
2.Press . The main menu will appear.
3.
3.Select 'TIMER' with or .
Then press .
4.
4.Select 'ONCE', 'DAILY' or 'WEEKLY' record-
ing with or . Then press
.
5.
5.
Select a TIMER block with . (The flashing
number indicates an empty TIMER block.)
6.
6.Press to delete information and input
correct information with .
7.
7.To end, press
.
8.
8.Switch off with
.
Problems and solutions for
programmed recordings
STANDBY/ON
yy
STATUS/EXIT
0..9
CLEAR
0..9
FWD 1- B
STOP C-LPLAY B-K
FWD 1- B
STOP C-LPLAY B-K
MENU
STANDBY/ON
yy
STATUS/EXIT
CLEAR
FWD 1- B
FWD 1- B
STOP C-LPLAY B-K
FWD 1- B
STOP C-LPLAY B-K
MENU
STANDBY/ON
yy
STANDBY/ON
yy
TURBO TIMER
EN
12
Error message : 'Err'
If this error message appears after pressing
, the start time or end time is
same as another recording.
TURBO TIMER
SELECT KL CHOOSE B
ONCE
DAILY
WEEKLY
→TIMER LIST
END=EXIT
ONCE
TIMER - 1 2 3 4 5 6 7 8 -
SELECT TIMER NUMBER
END=EXIT
Timer block disappeared when I pressed
.
You have checked all the programmed
recordings. If you want to check them again,
repeat steps 2 to 5.
FWD 1- B
Error message: ' ' flashes in the video
recorder display
• No cassette was inserted. Insert a cassette
and switch off the video recorder using
.
Cassette was ejected as soon as the
button was pressed
• A cassette without the security tab was insert-
ed. Undo the erase protection (chapter
'Manual recording', section 'Preventing acci-
dental erasing') or insert a different cassette.
'TURN OFF VCR FOR TIMER RECORDING'
flashes on the TV screen
• The video recorder is switched on several min-
utes before the start of a programmed recording.
Switch off the video recorder with
. A programmed recording (timer)
will only function when the video recorder is
switched off.
Cassette is ejected during recording
• The end of the tape was reached during record-
ing.
The video recorder does not react
• While a programmed recording is being made,
you cannot operate your video recorder manual-
ly. If you want to cancel the programmed record-
ing, press on the front panel.
STOP/EJECT
STANDBY/ON
yy
STANDBY/ON
yy
STANDBY/ON
yy
To Next Page
Loading...
