Philips UHP PHI/378 User Manual

Specification sheet UHP Replacement Lamps
Information in this document is subject to change without notice.
Document#: PHI/378-May.28-2008 Page 1 of 3
Philips UHP 100W/120W 1.0 E23
1. Specifications
• Customer part#:…………………PHI/378
• Lamp Application:………………..RP-TV
• Reflector type:…………………...Elliptical E23
• Arc gap:………………………….1.0 mm
• Power:…………………………...100W/120W
• Ignition voltage:………………….Ignition voltage 20kV ± 5kV
• Light output typical * :…………..4100 lumen (in 120W mode)
• Average Life time ** :…………...> 6000 hrs
• Environmental:…………………...RoHS and WEEE compliant
Side and back view of lamp. All dimensions ±0.5mm.
* : Lumen at aperture 4mm on pot
** : Ballast type Test conditions on UHP 120W electronic power supply (EUC-120P/11) stabilized at 120W

Philips UHP PHI/378 Specifications

General

Brand	Philips
Model	UHP PHI/378
Category	Home Lighting
Language	English

Summary

Specifications

Safety - Specific Attention Required for UHP Lamps

Mercury Hazard

Mercury is toxic. In case of bulb rupture, avoid inhalation and clean spills.

High Operating Lamp Temperature

Lamp and surrounding parts get extremely hot. Ensure device is cooled before touching.

High Intensity Light Beam

Lamp creates a high intensity beam. Never look directly into an operating lamp.

UV Radiation

Lamp generates UV radiation. Never look directly into an operating lamp.

High Voltage Ignition

High ignition pulses (5kV to 25kV) require safety protection for the lamp area.

Instruction for Use

Procedure for Disposal of Lamps

Environmental Laws

EU Regulations

At end of service life, UHP Lamps should be treated as chemical waste.

USA Regulations

Vermont law requires notification for mercury added products on lamps and packaging.