Philips VE8 - Page 32

Service Modes, Error Codes, and Fault Finding
EN 32 Q529.1A LA5.
• 2.3 MOP_RXSXX_x.x.x.x.zip. A separate MOP Ambient
Light FPGA SW. This SW is not part of the FUS
autorun.upg! A programmed MOP device can also be
ordered via the regional Service organization.
• 2.4 OAD_Q591X_x.x.x.x.zip. Not to be used by Service
Technicians.
• 2.45OpenSourceFile_Q591X_x.x.x.x.zip. Not to be used
by Service technicians.
• 2.6 PQPrivate_U5228_x.x.x.x.zip. Not to be used by
Service technicians.
• 2.7 PQPublic_U5228_x.x.x.x.zip. Not to be used by
Service technicians.
• 2.8 ProcessNVM_Q591X_x.x.x.x.zip. Default NVM
content. Must be programmed via ComPair.
• 2.9 StandbySW_CFTxx_x.x.x.x_commercial.zip.
Contains the Stand-by software in “upg” and “hex” format.
– The “StandbySW_xxxxx_prod.upg” file can be used to
upgrade the Stand-by software via USB.
– The “StandbySW_xxxxx.hex” file can be used to
upgrade the Stand-by software via ComPair.
– The files “StandbySW_xxxxx_exhex.hex” and
“StandbySW_xxxxx_dev.upg” may not be used by
Service technicians (only for development purposes).
• 3.0 stmp4_xxxx.xxxx.xxxx.zip. This is a separate
MPEG4 SW (is also part of the FUS autorun.upg). Not to
be used by Service Technicians.
• 3.1 UpgradeAll_Q591X_x.x.x.x_commercial.zip. Only
for production purposes, not to be used by Service
technicians.
Caution: Never try to use this file, because it will
overwrite the HDCP keys ! ! !
• 3.2 UpgradeExe_Q591X_x.x.x.x.zip. Not to be used by
Service Technicians.