Read and follow the steps below to record a television program.
1
Turn on the TV and set it to channel 3 or 4, whichever
channel the CH3/CH4 switch on the back of the VCRis set to.
Recording 31
2
Insert a tape with its record tab intact in the VCR.
4
If the VCR light appears on the display panel, go to step 5. If the
VCR light does not appear, press the VCR/TV button
once.
• If you press the REC(ord)/OTR but-
ton when there is not a tape in the
VCR, NOCASSETTE will flash on-
screen.
• If you press the REC(ord)/OTR but-
ton while a tape without a record
tab is in the VCR, the VCR will eject
the tape and PROTECTEDCAS-
SETTECANNOTRECORD will flash
on-screen.
• Other recording options are on
pages 32 - 42.
• You can change the tape speed
during a recording, but some distor-
tion will appear on the tape.
• The VCR will record in a preset vol-
ume.
Helpful Hints
5
Press the SPEED button until the desired tape speed
appears briefly on-screen. (Details about tape speed are on page
36.)
6
Use the CH(annel) o/p buttons or the Number buttons
to select the channel to be recorded.
7
Press the REC(ord)/OTR button once to start recording.
The REC(ord) light will appear.
8
To pause the recording, press the PAUSE/STILL button
once. The REC(ord) light will flash. To resume recording,
press the REC(ord)/OTR button or press the
PAUSE/STILL button again. The REC(ord) light will come on
again.
9
To stop recording, press the STOP/p button.
1
Turn on the TV.
2
Insert a tape in the VCR.
7
4
6
8
5
9
3
Press the VCR button.
3
ALT. CH
To Next Page
Loading...
