VCR PLUS+ PROG.
PLUS CODE : – – – – – – – –
TO END PUSH EXIT
40 Timer Recording with the VCR Plus+ Programming System
Follow these steps to set a timer recording with the PlusCode
programming numbers in your TV guide. Before you begin:
● Set up the channels at the VCR (page 12).
● Set up the VCRPlus+ and Cable/TV channel numbers (pages
38 - 39).
● Set the clock (pages 15-18).
● Put a tape in the VCR.
● Make sure the VCR light appears on the display panel. If it does
not, press the VCR/TV button once.
Do each step within 60 seconds of the previous step.
2
Press the VCR PLUS+/ENTER button.
3
Press the Number buttons to enter the PlusCode pro-
gramming number of the program you wish to record.
Then, press the VCR PLUS+/ENTER button.
VCR PLUS+ PROG.
PLUS CODE : 13285 – – –
TO SET PUSH VCR+
TO CORRECT PUSH CLEAR
TO END PUSH EXIT
4
Press the PLAY/o button or the STOP/p button to select
a ONCE, DAILY, or WEEKLY recording. Then, press the
F.FWD/B button.
● ONCE: The VCR will record a TV program on any day you
choose, up to 12 months away.
● DAILY: The VCR will record a program every day from
Monday to Friday – starting at the same time and recording for
the same length of time.
● WEEKLY: The VCR will record a program on the same day, at
the same time, and for the same length of time every week.
• CODE ERROR may flash on-screen
after step 3 if you enter an incorrect
PlusCode programming number (for
example, one that is too short). The
previous screen will appear. Enter
the correct PlusCode programming
number.
• If CLASH flashes on-screen after step
3, the timer recording you just pro-
grammed and another timer record-
ing overlap. The current timer record-
ing will not occur.
• You may use the VCR Plus+
Programming System to record pro-
grams on Cable TV channels up to
channel 99.
• If the VCR PLUS+ CROSS REF. MAP
reappears after step 3, the VCR
PLUS + channel number for the
recording you entered was higher
than 99. In this case, enter the cor-
rect CABLE/TV channel in the map.
Then, press the MENU button and
continue from step 4.
Helpful Hints
VCR PLUS+ PROG.
→ ONCE
DAILY
WEEKLY
SELECT op CHOOSE B
TO END PUSH EXIT
3
2
4
1
Press the VCR button.
1
ALT. CH
To Next Page
Loading...
