Philips Wisp - Removing the Mask

5
Using Tube Management (Optional)
The flexible tubing may be placed over head.
9. Slide the mask tubing through the headgear crown loop
i before attaching the flexible tubing.
Using the Mask
10. Connect the flexible tubing (included with the CPAP or bi-level device) to the swivel.
11. Turn the therapy device on. Lie down. Breathe normally.
12. Assume different sleeping positions. Move around until comfortable. If there are any excessive air
leaks, make final adjustments. Some air leaking is normal.
Comfort Tips
• The most common mistake is overtightening headgear. The headgear should fit loose and
comfortable. If the skin bulges around the mask or if red marks appear, loosen the headgear.
• Re-seat the mask by pulling it directly away from face and gently setting it back into place.
• Adjust the side headgear straps to reduce leaks around eyes.
Removing the Mask
Disconnect a bottom headgear clip. Slide the headgear forward over head.
Disassembly / Assembly
Reversible Fabric Frame
Choose the fabric that feels comfortable against the skin. That side will face inward toward the
cushion and headgear. The clear frame is not reversible.
Removing the Elbow and Tubing
1.
Squeeze the Quick Release Tabs j.
2. Pull the elbow away from the cushion k.
Removing the Cushion
Push the cushion backwards through the frame l.
Removing the Headgear
1. Detach the headgear bottom clips from the frame or undo the bottom tabs and pull.
2. Undo the headgear top tabs and pull the straps through the frame.