PHILODO H8 - Operating the LCD Display; Walk Mode; Cruise Control

- 21 -
Operating the LCD Display
es: The trip meter will reset when the eBike is powered
off. The maximum and average speed will be calculated
for a given trip, and will reset when the bike is powered
off. When the bike has not been used for 10 consecutive
minutes, the display will automatically shut down.The
pedal assist and throttle features will no longer work
when the display is turned off.
Walk Mode
In general, electric bikes are heavier than the non-electric
counterparts. This makes walking the bike a more
strenuous activity. To make walking the bike easier,
Philodo bikes are equipped with walk mode. If you hold
down the down button on the display control pad, the
motor will engage at a speed similar to a slow walk. When
walk mode is engaged, a “Walk” indicator will appear on
the display. To deactivate walk mode, simply pull the
brake levers to engage the motor inhibitors or press and
hold the down button.
Cruise Control
Turning the bike ON
Turn on the ignition switch,
Hold the power button until
the display turns on
Turning the bike OFF
Turn off the ignition switch
Increase Pedal Assist Level
Press up button
Decrease Pedal Assist Level
Press down button
Toggle Odometer, Trip,
Voltage, Trip Timer (TM),
Max Speed and Average
Speed
Press the power button
Enter walk mode
Hold the down button
Enter cruise speed
Twist and hold the throttle
while holding the down
button