when cruise control was activated. For example, if the
throttle is held all the way from its resting position (to a
position that would normally maintain 20km/h) and the
down button is held, cruise control will be activated and
set at 20km/h. Even if the bike is currently going slower
than 20mph, the bike will try to accelerate and maintain
that speed because it was set based on that throttle
position. To cruise at low speeds, only slightly press the
throttle and hold the down button. Cruise control can be
deactivated at any time by pulling the brakes or pressing
the throttle again, or holding the down button. This will
also cut power to the motor as it would during normal
operation.
Display Settings
To change display settings, hold the up and down button
simultaneously to enter into the advanced settings menu.
In this menu, clicking the power button will toggle
between each numbered setting. To adjust the value of
each setting, click the up and down buttons accordingly.
Setting Function Default Explanation
P01
Brightness
2
Backlight display brightness.
The darkest level is 1, the
brightest level is 3.
P02
Distance
Units
0
Distance Units. 0: KM; 1: MILE.
P03
Voltage
48
Voltage of the motor. Do no
change it.
P04 Sleep 10
LCD Display sleep timer. With the
default setting, the display will turn
off after it has not been used for
10 minutes.
P05 PAS Gear 0 5
The pedal assist level ranges 0 to
5.
To Next Page
Loading...
