shows the estimated charge left in the bike’s battery. As the
battery depletes, tick marks will begin to disappear according
to approximately how much charge in the battery has been
used. The various charge level indicator states are shown
below. The battery display will flash when there is no charge
remaining.
Note: The energy bar will not always be accurate. The energy
bar updates every few minutes based on the current voltage
of the battery.
FULL EMPTY
TIPS WHEN RIDING TO INCREASE RANGE
To get the maximum range out of your bike there are some
simple things you can do:
•Ride in a lower level of pedal assist
•Use lower assist levels and pedal when climbing hills
•Pedal when starting from a standstill
•Set your max speed lower than 25 km/h on the LCD display
The range the bike can go on a single battery charge can vary
significantly between riders, terrain, wind conditions, user
input, and additional payload weight.
Troubleshooting
If your bike is not operating normally, there are some simple
steps that can be taken to remedy the situation quickly. There
may or may not be an error code that pops up on the screen
depending on the issue. Solutions to common problems, as
well as error code meanings, can be found below. If you have
any questions at all regarding the basic troubleshooting below,
reach out to Philodo Bikes customer support.
To Next Page
Loading...
