How to fix Phocos Battery Charger when the unit shuts down automatically during start-up process?
If your Phocos Battery Charger shuts down automatically during the start-up process, it's likely because the battery voltage is too low (less than 45.84V/22.92V for the 48V/24V model). To resolve this, first try to re-charge the battery. If the issue persists, you may need to replace the battery.
Why does my Phocos Inverter show error A011?
If the Phocos Inverter displays error A011, it indicates that the public grid disconnected. Check if the inverter AC connection is correct.
What does error E005 mean on my Phocos Inverter?
If the Phocos Inverter displays error E005, this indicates an internal AC overcurrent.
Why Phocos Controller battery voltage is too high?
If the battery voltage is too high on your Phocos Controller, check if the specifications and quantity of batteries meet the requirements.
What to do if Phocos Any-Grid Battery Charger has no response after power on?
If your Phocos Battery Charger doesn't respond after you power it on, the battery voltage may be too low (less than 33.6V/16.8V for the 48V/24V model) or the battery polarity is connected in reverse. First, check if the batteries and wiring are correctly connected, paying attention to the battery polarity. Then, try recharging the battery. If the issue continues, consider replacing the battery.
What to do if EEPROM corrupted on Phocos Any-Grid Battery Charger?
Please contact your repair center and communicate the serial number of the affected unit.
What does error E013 mean on a Phocos Inverter?
If the Phocos Inverter shows error E013, it indicates an internal memory error.
What does error E014 mean on a Phocos Inverter?
If the Phocos Inverter shows error E014, it means there is high DC injection during AC output.
What to do if Phocos Controller output voltage is unbalanced?
If the output voltage of your Phocos Controller is unbalanced, it could be due to the battery not being connected correctly or an internal fuse blown. If the battery is connected correctly, please return to repair center.
What does error E009 mean on a Phocos Inverter?
If the Phocos Inverter shows error E009, it means the master-slave DSP communication is disabled or there is an error of master-slave DSP check bit.
General| Brand | Phocos |
|---|---|
| Model | Any-Grid Series |
| Category | Battery Charger |
| Language | English |
To Next Page
