Output Power per Channel at 1% THD (all channels driven)
Into 4 ohms @ 12.0 VDC ..................................24 watts x 2
Into 4 ohms @ 14.4 VDC ..................................35 watts x 2
Into 2 ohms @ 14.4 VDC ..................................60 watts x 2
Into 1 ohm @ 14.4 VDC ....................................93 watts x 2
Into 1/2 ohm @ 14.4 VDC .................................150 watts x 2*
Bridged into 4 ohms @ 14.4 VDC .....................125 watts x 1
Bridged into 2 ohms @ 14.4 VDC .....................185 watts x 1
Bridged into 1 ohm @ 14.4 VDC.......................300 watts x 1*
Frequency Response ........................................±1dB from 20Hz to 20kHz
Signal to Noise Ratio.........................................>100dB
Lowest THD.......................................................0.02%
Damping Factor.................................................500 to 1
Input Sensitivity .................................................200 millivolts to 2 volts
Input Impedance................................................30k ohms
Input Voltage Range..........................................10.5 volts to 15.0 volts
Typical current draw at idle................................3 amps
Continuous current draw @ full power**............30 amps
Peak current draw @ full power*** ....................40 amps
Bass Boost........................................................+12 dB @ 45 Hz
Recommended Fuse Size.................................40 amps
Dimensions........................................................8.5"L x 11.4"W x 2.4"H
* Low impedance operation requires cooling fans, large gauge power cable and at
least 1 farad of capacitance. MINIMUM SPEAKER LOAD IS 1 OHMS BRIDGED OR 1/2
OHM STEREO.
** Average continuous current draw when playing typical music material
*** Average peak current needed for musical peaks (<20 ms) when playing typical
music material.
To Next Page
Loading...
