Need help?Do you have a question about the Phoenix Amplifier and is the answer not in the manual?
Details the amplifier's exterior styling, custom aluminum case, cooling vents, and LED indicator.
Explains Xe.Tune™ controls, Linkwitz-Riley crossovers, and standard features like LPL and RMD ports.
Covers CEA-2006 standard ratings, birth certificates, and Xe.Load™ technology for load handling.
Discusses the Triple Darlington output stage for multi-channel and Class D for monoblocks.
Features Xe.Flow™ technology, heatsink design, variable speed fan, and thermal protection.
Highlights increased output devices, bussbars, low ESR capacitors, and robust design for durability.
Details component selection, ESR reduction, and Sanken output transistors for superior audio.
Lists frequency response, S/N ratio, crossover ranges, bass boost, input sensitivity, and load for monoblock models.
Details specs like frequency response, S/N ratio, crossover ranges, bass boost, and input sensitivity.
Details how to connect speakers, including minimum cable size and impedance.
Explains the input for the optional Remote Voltage Display.
Describes connecting preamp signal cables and recommends specific interconnects.
Provides a full range signal for an additional amplifier.
Port for connecting the optional Remote Lowpass Level Control knob.
Details connections for fused positive, remote switched +12V, and negative terminals.
Blue LED indicates amplifier status; blinking signifies protection mode.
Adjusts amplifier sensitivity to input signals for optimal power.
Controls the low pass crossover point, eliminating high frequencies.
Controls the high pass crossover point, eliminating extreme low frequencies.
Provides up to 18dB boost at 45Hz for speaker outputs; use sparingly.
Details connecting speakers for stereo and bridged modes, including cable size and impedance.
Explains the input for the optional Remote Voltage Display.
Describes connecting preamp signal cables and recommends specific interconnects.
Provides a full range signal for an additional amplifier.
Port for connecting the optional Remote Lowpass Level Control knob.
Details connections for fused positive, remote switched +12V, and negative terminals.
Blue LED indicates amplifier status; blinking signifies protection mode.
Adjusts amplifier sensitivity to input signals for optimal power.
Controls the high pass crossover point, eliminating low frequencies.
Controls the low pass crossover point, eliminating high frequencies.
Provides up to 18dB boost at 45Hz for speaker outputs; use sparingly.
Button to enable or disable crossovers, creating bandpass filter when both are on.
Details connecting speakers for stereo and bridged modes, including cable size and impedance.
Describes rear input for fader control and front input for the entire amplifier.
Explains the input for the optional Remote Voltage Display.
Describes connecting preamp signal cables and recommends specific interconnects.
Provides a full range signal for an additional amplifier.
Port for connecting the optional Remote Lowpass Level Control knob.
Details connections for fused positive, remote switched +12V, and negative terminals.
Blue LED indicates amplifier status; blinking signifies protection mode.
Adjusts amplifier sensitivity to input signals for optimal power.
Controls the high pass crossover point, eliminating low frequencies.
Controls the low pass crossover point, eliminating high frequencies.
Provides up to 18dB boost at 45Hz for speaker outputs; use sparingly.
Button to enable or disable crossovers, creating bandpass filter when both are on.
Explains dual power terminals, parallel wiring, and capacitor connection for specific models.
Step-by-step guide for mounting the amplifier and feeding wiring through terminal covers.
Outlines warranty period, coverage, exclusions, and conditions for amplifier defects.
Recommends using Meguiar's rubber protectant for cleaning and maintaining rubber components.
To Next Page
General