tighten it firmly. You will not need any tools to
tighten the nut. The rubber rings will hold the
tap in place preventing leakage.
Step 3:
Place the base rubber ring (F) on a flat surface
and place the lower chamber of the housing (C)
over it. Applying pressure gently, fit the rubber
ring in place.
Step 4:
Using the similar technique as in
step 2, attach the two provided
cartridges (E) to chamber (B).
Step 5:
Finally place chamber (B) over chamber (C) and
close it with the lid (A).
The installation of the filter is now complete,
hassle free.
To Next Page
Loading...