Phonak Roger iN User Manual

Phonak Roger iN microphone installation guide 2
5. Place the hearing device close to the Roger iN microphone (within 10 cm / 4 inches)
6. Wait approximately 5 seconds until the indicator light on the Roger iN microphone turns solid green
7. Repeat step 2. to 6. with the second hearing device.
Note: The hearing device(s) will automatically be connected to the Roger iN microphone.
In case the indicator light turns red after the installation procedure, the installation was not successful. This could be for the
following reasons:
- The distance between the Roger iN microphone and the hearing device was too far
- There are no Roger receivers installed on the Roger iN microphone
- The hearing device already has Roger installed
- The hearing device is not RogerDirect compatible.
Checking number of Roger receivers in a Roger iN microphone
After turning on the Roger microphone, briefly press the install button on the Roger iN microphone:
Roger Select iN Roger Table Mic II iN Roger Pen iN
The indicator light feedback will tell you the number of installed Roger receivers:
Two Roger receivers installed
One Roger receiver installed
No Roger receiver installed

Phonak Roger iN Specifications

General

Battery Life	Up to 8 hours
Technology	Roger technology
Type	Wireless microphone
Operating Range	Up to 20 meters (65 feet)
Microphone Type	Directional
Connectivity	Roger wireless technology
Charging Time	3 hours
Frequency Range	2.4 GHz