Phonak Roger iN User Manual

Phonak Roger iN microphone installation guide 3
Uninstalling Roger receiver from a hearing device
Uninstallation steps:
1. Switch on the Roger iN microphone
2. Press and hold the install button for two seconds until the indicator light starts to blink green
Roger Select iN Roger Table Mic II iN Roger Pen iN
3. Place the Roger iN microphone on the table
4. Switch on one hearing device (keep other hearing devices switched off)
5. Place the hearing device close to the Roger iN microphone (within 10 cm / 4 inches)
6. Wait approximately 5 seconds until the indicator light on the Roger iN microphone turns solid green
7. Repeat step 2 to 6 with the second hearing device if needed.
In case the indicator light turns red after the uninstallation procedure, the uninstallation was not successful. This could be
for the following reasons:
- The distance between the Roger iN microphone and the hearing device was too far
- The Roger iN microphone has already two Roger receivers installed
- The hearing device does not have Roger installed
- The hearing device is not RogerDirect compatible.
V1.00/201
9-05 © Sonova AG All rights reserved

Phonak Roger iN Specifications

General

Battery Life	Up to 8 hours
Technology	Roger technology
Type	Wireless microphone
Operating Range	Up to 20 meters (65 feet)
Microphone Type	Directional
Connectivity	Roger wireless technology
Charging Time	3 hours
Frequency Range	2.4 GHz