Phonak Roger iN User Manual

Roger iN microphone installation guide
Contents
Installing Roger receivers into a pair of hearing devices with RogerDirect™ ............................................................................................. 1
Checking number of Roger receivers in a Roger iN microphone .................................................................................................................... 2
Uninstalling Roger receiver from a hearing device ............................................................................................................................................ 3
Installing Roger receivers into a pair of hearing devices with RogerDirect™
Make sure the hearing instrument contains the latest FW that is available in Phonak Target 6.1 or higher.
Installation steps:
1. Switch on the Roger iN microphone
2. Press and hold the install button for two seconds until the indicator light starts to blink green:
Roger Select™ iN Roger Table Mic II iN Roger Pen™ iN
3. Place the Roger iN microphone on the table
4. Switch on one hearing device (keep other hearing devices switched off)
Phonak
Roger™ iN microphones

Phonak Roger iN Specifications

General

Battery Life	Up to 8 hours
Technology	Roger technology
Type	Wireless microphone
Operating Range	Up to 20 meters (65 feet)
Microphone Type	Directional
Connectivity	Roger wireless technology
Charging Time	3 hours
Frequency Range	2.4 GHz

Summary

Installing Roger Receivers

Installation Procedure

Steps to pair Roger iN microphones with hearing devices, including device placement and indicator light confirmation.

Checking Roger Receiver Count

Indicator Light Feedback

Interpreting indicator light signals to determine the number of Roger receivers installed on the microphone.

Uninstalling Roger Receivers

Uninstallation Steps

Procedure for removing Roger iN microphones from hearing devices, involving button presses and device proximity.