Phonak Roger Select How To Connect

Connecting to Computers/Tablets
1. Make sure you have switched on your Roger Select.
2. Plug the rectangular end of the short audio cable into the bottom of your Roger Select.
3. Plug the round end of the short audio cable into the headphone
output of your computer or portable device. Figure 3
4. Select “Headphones” from the pop up menu on your computer. Figure 4
5. Control volume by clicking on speaker icon on the bottom right corner of your computer screen. Figure 5
Figure 3
Figure 4
Figure 5

Phonak Roger Select Specifications

General

Battery Life	Up to 8 hours
Operating Range	Up to 20 meters
Compatibility	Roger receivers
Frequency Range	2.4 GHz
Water Resistance	IP54
Charging Time	3 hours