Odin II TTL Flash Trigger for Canon
Thank you for purchasing a Phottix product
Note: Before using the Odin II TTL Flash Trigger for Canon, please read this
instruction manual carefully.
Odin II TTL Flash Trigger is a new generation of TTL triggering system based on the
previous Odin TTL Flash Trigger. While keeping the Odin system’s core functions
such as of wireless power level adjustment, zoom adjustment and etc, the new system
has been added with a series of innovative functions to extend its utility and stability,
including group/channel/ID settings, AF assist light, wireless modeling light
brightness control. A whole new structural design allows for easier and faster to
operation.
Many TTL flashes have been tested but the manufacturer cannot guarantee that all
third party TTL flashes will function properly with the Phottix Odin II. It is designed
and optimized for Canon Flashes using the ETTL II/ETTL system.
Please Note:
1. After turning on the Phottix Odin II transmitter and receivers, slave mode does
not need to be set on flashes on Photix Odin II receivers, but flashes need to be set
in ETTL mode.
2. Ensure there is a good hot shoe connection between the transmitter and camera,
flashes and receivers for best performance.
3. Many TTL flashes have been tested but the manufacture cannot guarantee that all
third party TTL flashes will function properly with the Phottix Odin II. It has been
designed and optimized for original canon flashes using the ETTL II/ETTL system.
4. Turn of all devices-flashes/strobes, camera, and the Phottix Odin II transmitter
and receivers when connecting and disconnecting the devices.
FCC Interference Statement:
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
FCC Radiation Exposure Statement:
This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This device and its antenna must not be co-located or
To Next Page
Need help?
General
