Phottix Strato TTL - Wired Shutter Release Operation; Using the Strato TTL as a wired shutter release; Notes on wired release functionality and compatibility.

15
INSTRUCTION MANUAL
EN
connected to receivers on the same channel.
It will not fire the flashes connected to the
receivers on the same channel.
*On compatible cameras
Using the Strato TTL as a wired
shutter release*
1. Turn off the camera and the Strato TTL
receiver.
2. Attach the correct Phottix Accessory Cable
for your camera make and model to the 2.5
mm Accessory Port on the Strato TTL receiver
3. Attach the other end of the cable to the
camera’s remote port.
4. Turn on the camera and Strato TTL
receiver**.
5. Consult your camera manual for specific
settings for remote use.
6. The Strato TTL receiver will function as a
wired shutter release. The shutter button
functions the same as a camera shutter
button: A half-press of the shutter button will
autofocus, a full press will take a photo.
*On compatible cameras
**Wired Shutter Release function can be used
without turning on the Strato TTL receiver,
and will function without batteries in the
receiver.