Phottix Strato TTL - Turning Transmitter and Receiver On;Off; Steps to power the device on and off.; Test Button Functionality; Functionality and usage of the test button for flashes.

7
INSTRUCTION MANUAL
EN
sync mode will not support Second Curtain
Sync (SCS) functions.
-If not using a 1Dx camera ensure this mode
is disabled for best results.
Turning transmitter and receiver on/
o
1. To turn on the Phottix Strato TTL
transmitter or receiver– move the power
switch to the “ON” position.
2. To turn off the Phottix Strato TTL
transmitter or receiver - move the power
switch to the “OFF” position.
Test Button
1. The Test Button will test re ashes/strobes.
2. To Test: Press the transmitter Test Button.
Flashes connected to Phottix Strato TTL
receivers on the same channel will re when
the transmitter test button is pressed.
3. Pressing the receiver Test Button will test
fire flashes or strobes connected to that
receiver.
For Wireless Shutter Release: See Using the
Strato TTL as a wireless shutter release below
Status LED
1. The Status LED on the Strato TTL transmitter
will flash green once every 2 seconds while
the power is on and turn solid green upon a
half-press of the shutter button (on camera
or the Strato TTL transmitter being used as