“OPERATION INSTRUCTIONS”
HOW TO ADJUST THE ADJUSTING ENDCAPS OF THE REAR STABILIZER
a. After placing the equipment in the intended location for use, check the
stability of the equipment
b. If it’s the one of the Adjusting Rear Stabilizer EndCaps (34) on rear
end of the Rear Stabilizer (4) causes a slight rocking motion. To level
the equipment, turn one or both of the Adjusting Rear Stabilizer
EndCaps (34) in clockwise or counter-clockwise direction until the
equipment sets on the floor without rocking
HOW TO ADJUST MAIN FRAME’S LEVELER
a. After placing the equipment in the intended location for use, make sure
the Adjusting Rear Stabilizer EndCaps (34) are well adjusted for
leveling the item
b. The purpose of the Leveler (35) is to support the middle Main Frame,
adjust Leveler (35) under the Main Frame (1) until it rests firmly on the
floor
c. To make the Leveler (35) rests firmly on the floor, turn the Leveler (35)
counter-clockwise until the Leveler (35) touches the floor without
rocking
HOW TO TOW THE ITEM SAFELY
Hold the Rear Stabilizer (4) up with two hands and tow the item
to the desired place carefully
Make sure the floor is level while towing the item
To Next Page
Loading...