PI 85110 - User Manual

To Next Page

- 1 -

PKI-0005-2

Thank you for purchasing the PIAA Sports Horn System

Installation Instructions

SPORTS HORN

1.Do not remove or alter the screw or the bracket on the back side of the horns.

Doing so may alter their performance or may disable them.

2.Install the horns so the open end with the co

ver points down.

3.Do not install and wire the PIAA Sports Horns so they work with the factory

installed horns. Doing so may overload the circuit or may not pass local

noise regulations.

4.Install the PIAA Sports Horn in a location that will not get direct water spray

or dust.

5.Install the PIAA Sports Horns in a location that is away from hot

engine components.

6.Do not paint or a

pply any type on chrome plating or powder coating

to the PIAA Sports Horn. Doing so may alter the tone or function of the horn.

CAUTION

Please read this entire manual before installation and use.

Your specific installation may require additional wiring connectors

that are commonly available.

DO NOT REMOVE! DO NOT REMOVE!

DO NOT REMOVE!

Need help?

Do you have a question about the PI 85110 and is the answer not in the manual?

Summary

Installation Types

Installation Type A

Connects two factory horns, each with two 1/4" blade connectors to PIAA Sports Horns.

Installation Type B

Installs two factory horns, each using a single wire plug, to PIAA Sports Horns.

Installation Type C

Connects a single factory horn with a single wire plug to PIAA Sports Horns.

Installation Type D

Connects a single factory horn with two 1/4" blade connectors to PIAA Sports Horns.

General Wiring