minutes and shut it off. After five minutes check the
level and if necessary top up without exceeding the
MAX level. The cartridge filter must be replaced
every time the oil is changed.
N.B.
THE ENGINE MUST BE HOT WHEN THE OIL IS
CHANGED.
Recommended products
AGIP CITY HI TEC 4T Engine oil
SAE 5W-40 Synthetic oil that exceed the require-
ments of API SL, ACEA A3, JASO MA specifica-
tions
Characteristic
Engine oil
1.3 l
Check
This operation must be carried out with the en-
gine cold and following the procedure below:
- Place the vehicle on its centre stand and on flat
ground.
- Make sure the adjustment of the rear suspension
is set to the minimum preloading position.
- Unscrew the cap/dipstick «A», dry it with a clean
cloth and reinsert it, by screwing it in complete-
ly.
-Remove the cap/dipstick «A» again and check
that the level is between the MAX and MIN marks.
top-up, if required.
If the check is carried out after the vehicle has
been used, and therefore with a hot engine, the
level line will be lower; in order to carry out a cor-
rect check, wait at least 10 minutes after the en-
gine has been stopped so as to get the correct
level.
Oil top up
X7 250ie Maintenance
MAIN - 9
To Next Page
Loading...
Need help?
General
