5
General operating notes
Even when not in use, your piano and control box continue to consume a small amount of power.
Disconnecting your piano from the power source completely shuts down the unit.
If your piano or PianoDisc Prodigy control box fails to operate in a manner consistent with the
instructions in this manual, please disconnect it from your power source and contact an authorized
PianoDisc dealer or a certified PianoDisc technician in your area.
Power
Make sure the correct power source is available.
• In the United States, your PianoDisc system uses a standard 120-volt AC household electrical
outlet as a power source.
• In other countries, PianoDisc systems are usually equipped with a power supply and cord that
are compatible with the prevailing voltage standards of that geographic area.
If you have questions concerning compatibility with local electrical standards, please consult your
PianoDisc retailer before connecting your PianoDisc system to a power source.
Power source connection
• For systems installed on vertical (upright) pianos, the electrical cord is usually found extending
from a small hole in the back of the piano. Make sure the cord is securely plugged into the outlet
before moving the piano against the wall. Do not crush the cord or plug under or against the
piano.
• For systems installed on grand pianos, the electrical cord extends from the power supply. The
power supply is usually mounted on a support beam under the piano. Plug the electrical cord
securely into a power source and avoid placing the cord where it becomes a tripping hazard.
• If speakers and/or other peripherals are installed, purchase a surge protector to distribute
power to each device. Mount the surge protector underneath the piano and attach it to the side
of the beam. Plug it into the wall, then plug the speakers, peripherals, and power supply into the
surge protector.
To Next Page
Loading...