Page 6 of 9
SwiftNet™ Disassembly Instructions
Safety: Never try to remove the Boom from the Netting while it is under tension.
Serious injury could result. Always be certain to fully release the Tensioning Net
Cord from both of the Top End Caps before attempting to take the net apart.
Step One: Remove Center Stand
Remove the Center Stand Support (shaped like an “A) from the middle of the Boom and place it the pouch of
the carry bag.
Step Two: Undo the Center Strap
Loosen the Center Strap on the Netting by pulling the Velcro end apart. If the Center Net Strap Adjuster was
utilized, just leave it in place on the Center Strap. There is no need to disassemble it.
Step Three: Release Tension
Lift the Net Tension Cord straight up on one of the Top End Caps so that it is released from the tensioning
mechanism. Do this until the tension is fully released like the picture below. Now do the same on the other
side. The Boom should no longer have a big bow to it.
To Next Page
Loading...